Feedback

  • Contents
 

AudioCodes and Genesys Board Configuration

Use this page to configure AudioCodes and Genesys boards.

MAC Address

Enter the MAC address in the format as  XX-XX-XX-XX-XX-XX.

Master

Use this check box if this board is the clock master for the bus.

H.100 Termination

If checked, the AudioCodes or Genesys card will provide software termination of the H.100 bus. This check box should only be checked if the corresponding card is physically located at the end of all telephony cards installed in a server and is the last card on the H.100 bus.

IP Address

Enter the IP address assigned to the board. It is in the dotted decimal form, for example, 10.12.1.15.

Subnet Mask

Enter the Subnet mask of the network to which the AudioCodes or Genesys board is attached. It is in the dotted decimal form, for example 255.255.0.0.

Default Gateway

Enter the IP address of the default gateway machine. It is the dotted decimal form, for example, 10.12.1.1.

Server

Enter the server name where the  AudioCodes or Genesys board is installed.

Port Duplex

Select the port duplex from the hardware list control. Each board should be configured for "Half", "Full", or "Auto", where "Auto" is the default.