T1/E1 Wink Event Initiator

This initiator starts when a wink is received on a line, providing a way to start a handler for special processing when a wink is received. Lines are configured to receive winks in the spanti.prm file located in the \Dialogic\data directory. You can change the wink definition for a single span. If you want to change the definition of the wink for a single span, you must edit the file and rename it for the span. The name of the new file must then be entered for the particular span into the parameter field in the misc table of the DCM. Only one wink definition can be defined for each E1/T1 line.

Notes: This wink is not the wink used in wink start mode. Lines are configured to be either wink or immediate start in the line configuration under IA. What a wink looks like (wink definition) is in the spandti.prm file.

This initiator will not start when receiving the initial wink on an outbound call on a wink start line.

Initiator Properties Page

For more information on the relationship between the parameters on the Initiator Properties page, see Introduction to Initiators.

Notification Object Type

Call

Object ID

{all}

Outputs

Call Identifier

The identifier for the call on which the wink was sent.

Exit Paths

Start

This step always exits through the start path.