Show Hide

 

Feedback

  • Contents
 

Delete and Redefine Array Configuration

You can delete and redefine an existing RAID when its configuration is invalid or does not match required settings.

Delete the drive arrays

  1. Open the HP Smart Storage Administrator and select the appropriate array controller.

  2. Under Actions, select Clear Configuration.

  3. Review the warning and click Clear to confirm.

    4. Note: Once you confirm the clear operation, the system removes all data from the logical drive. You cannot recover data after this operation.

  4. When the controller configuration clears, click Finish.

  5. Repeat the procedure to delete all drive arrays.

Redefine the arrays

After deleting all arrays, redefine them.

  1. Under Actions select Create Array.

  1. Follow the steps in the table below, using the configuration requirements for your particular server, to recreate the array configuration required by the device.

    Device Type

    RAID Configuration Steps

    Interaction Application Server

    Recreate logical drives to match the RAID configuration for the model you are using:

    Model

    RAID Configuration

    360 Gen10 Medium

    Single RAID 1+0 logical drive, consisting of 4 HDDs

    360 Gen10 Large

    Single RAID 1+0 logical drive, consisting of 4 HDDs

    380 Gen10

    Single RAID 1+0 logical drive, consisting of 8 HDDs

    1. Create the required Logical Drive Array by selecting its physical drives.

    2. Click Create Array (see Select Physical Drives for the New Array in Appendix A).

    3. Under RAID Level select RAID 1+0.

    4. Under Size select Maximum Size. Leave remaining settings at default.

    5. Click Create Logical Drive (see Create Logical Drive in Appendix A).

    6. Click Finish once the logical drive creates successfully.

    When finished, the configuration should match the RAID Configuration for the model that you have.

    Interaction Media Server™

    Recreate logical drives to match the RAID configuration for the model you are using:

    Model

    RAID Configuration

    360 Gen10 Small

    Single RAID 1 logical drive, consisting of 2 HDDs

    360 Gen10 Medium

    Single RAID 1+0 logical drive, consisting of 4 HDDs

    360 Gen10 Large

    Single RAID 1+0 logical drive, consisting of 4 HDDs

    1. Create the required Logical Drive Array by selecting its physical drives.

    2. Click Create Array (see Select Physical Drives for the New Array in Appendix A).

    3. Under RAID Level, select RAID 1+0.

    4. Under Size select Maximum Size. Leave remaining settings at default.

    5. Click Create Logical Drive (see Create Logical Drive in Appendix A).

    6. Click Finish once the logical drive creates successfully.

    When finished, the configuration should match the RAID Configuration for the model you have.