Wink

This Telephony tool is used to send a wink on a digital line to a CO (Central Office) while the call is in the "Connected" state. You must, for this reason, define the wink as an "inverse wink" (at least one bit is high, low and high again). A wink is defined (for all T1/E1 spans, unless override in the DCM (Dialogic Configuration Manager)) in the spandti.prm file located in the \Dialogic\data directory; you must edit this file in order to change the definition of the wink. If you want to change the definition of the wink for a single span, you must edit the file and rename it for the span. The name of the new file must then be entered for the particular span into the parameter field in the misc table of the DCM. Only one wink definition can be defined for each E1/T1 line.

Any line on a T1/E1 span on which you change the wink definition (to be an inverse wink) cannot not be configured as "Wink start" since "Wink Start" uses a regular wink.

Inputs

Call Identifier

The identifier for the call on which the wink is sent.

Exit Paths

Next

This tool always takes the Next exit path.